K-array KA24 Manuel d'utilisateur télécharger pdf (Page 16)

KA24/KA84

PRELIMINARY

DEL AY

The Delay page allows users to independently set the

delays for the four output channels (up to 3.5 mt) and for

Channel 3 and Channel 4 input channels (up to 114 mt).

Pressing on a delay value, users can set the delay in ms

or in mt. Press the OK button to return to the Delay page.

CONFIGURATION

Before connecting the speakers to the amplifier, follow

the instructions below.

Warning. Failure to follow these instructions

could result in serious damage to the

speakers connected to the amplifier!

Go to the Configuration page and press the SETUP

button Insert the model and the number of speakers

connected to Output A1. Press the arrow button on the

top right corner.

Insert the model and the number of speakers you

want to match to the previous ones. For example if you

have two KP102 mid-high arrays connected to an A1

output and a KMT21P sub connected to another output

(or to another amplifier) select KMT21P to the A1 Out

Match page and the DSP will compute automatically the

crossover setting to obtain a perfect match between the

speakers. Press the arrow button on the top right corner.

Repeat step 2 and 3 for all other outputs. At the and

you will return to the main Configuration page. Press

APPLY to load all settings. The DSP will automatically

adjust the output gain and the crossover on each output

channel to match the requirement for the speakers

connected.

Warning. If you are using speakers with selectable impedance, pay

attention to set the value indicated in the Configuration page!

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

K-array KA24 Manuel d'utilisateur Page 16